TEK 2225 - Page 4

2225 Service
TABLE OF CONTENTS (cont)
Page
Page
Section
4 PERFORMANCE CHECK PROCEDLIRE Section 5 ADJUSTMENT PROCEDLIRE
INTRODUCTION ................ 4-1
PERFORMANCE CHECK
..................
INTERVAL 4-1
STRUCTURE
................ 4-1
TEST EQUIPMENT
REQUIRED
.................. 4-1
LIMITS AND TOLERANCES ..... 4-1
PREPARATION FOR
CHECKS
................... 4-1
INDEX TO PERFORMANCE
CHECK STEPS
.............. 4-3
VERTICAL
.................... 4-4
INITIAL CONTROL
SETTINGS
.................. 4-4
PROCEDURE STEPS
.......... 4-4
HORIZONTAL
................. 4-8
INITIAL CONTROL
SETTINGS
.................. 4-8
PROCEDURE STEPS
.......... 4-8
TRIGGER
.................... 4-12
INITIAL CONTROL
SETTINGS
................. 4-1 2
PROCEDURE STEPS
......... 4-1 2
EXTERNAL Z-AXIS AND
PROBE ADJUST
.............. 4-1 5
INITIAL CONTROL
SETTINGS ................. 4-1 5
......... PROCEDURE STEPS 4-1 5
INTRODUCTION
............... 5-1
.................. PURPOSE 5-1
............... STRUCTURE 5-1
TEST EQUIPMENT
REQUIRED
................. 5-1
LIMITS AND TOLERANCES
.... 5-1
ADJUSTMENTS AFFECTED
BY
REPAIRS .................. 5-1
PREPARATION FOR
ADJUSTMENT
.............. 5-1
INDEX TO ADJUSTMENT
PROCEDURE STEPS
......... 5-3
POWER
SLIPPLY AND
................ CRT DISPLAY 5-4
INITIAL CONTROL
SETTINGS
................. 5-4
PROCEDURE STEPS
......... 5-4
VERTICAL
................... 5-6
INITIAL CONTROL
SETTINGS
................. 5-6
PROCEDURE STEPS
......... 5-6
HORIZONTAL
................ 5-13
INITIAL CONTROL
SETTINGS
................ 5-13
........ PROCEDURE STEPS 5-13
TRIGGER
................... 5-18
INITIAL CONTROL
SETTINGS
................ 5-18
PROCEDURE STEPS
........ 5-18
EXTERNAL Z-AXIS AND
............. PROBE ADJUST 5-22
INITIAL CONTROL
................
SETTINGS 5-22
........ PROCEDURE STEPS 5-22
Scam by ARTEK MEDL4 *