2225
Service
OPERATORS SAFETY SUMMARY
The safety information in this summary is for operafing personnel. Warnings and cautions will also
be
found
throughout the manual where they apply.
Terms in this Manual
Grounding the Product
CAUTION statements identify conditions or practices
This product is grounded through the grounding con-
that could result in damage to the equipment or
ductor of the power cord. TO avoid electrical shock,
other property.
plug the power cord into a properly wired
recepta-
cle before making any connections to the product
WARNING statements identify conditions or practices
input or output terminals. A protective ground
con-
that could result in personal injury or loss of life.
nection, by way of the grounding conductor in the
power cord, is essential for safe operation.
Terms as Marked on Equipment
Danger Arising From Loss of Ground
CAUTION indicates a personal injury hazard not im-
Upon
loss
of
the
protective-ground connection,
all
mediately accessible as one reads the markings, or
accessible
conductive
parts,
including
knobs
and
a
hazard
property, including
the
itself' controls that may appear to be insulating, can ,-en-
DANGER indicates
a
personal injury hazard immedi-
der an electric shock.
ately accessible as one reads the marking.
Use the Proper Power Cord
Symbols in this Manual
Use only the power cord and connector specified for
your product.
This symbol indicates where applicable
cautionary or other information is to
Use only a power cord that is in good condition.
be found. For maximum input voltage
see Table
1-1
.
For detailed information on power cords and con-
nectors, see Figure
2-2.
Symbols as Marked on Equipment
Use the Proper Fuse
1
DANGER-High voltage.
@
Protective ground (earth) terminal.
A
ATTENTION-Refer to manual.
Power Source
To avoid fire hazard, use only a fuse of the correct
type, voltage rating and current rating as specified in
the parts list for your product.
Do Not Operate in an Explosive
To avoid explosion, do not operate this instrument in
an explosive atmosphere unless it has been specifi-
cally certified for such operation.
This product is intended to operate from a power
source that does not apply more than
250
V
rms
DO Not Remove Covers or Panels
between the supply conductors or between either
supply conductor and ground. A protective ground
To avoid personal injury, do not remove the product
connection, by way of the grounding conductor in
covers or panels. Do not operate the product
with-
the power cord, is essential for safe operation.
out the covers and panels properly installed.
Scans
by
ARTEK
MEDU
=>
To Next Page
Loading...