EasyManua.ls Logo

Teka HLC 847 SC - Residual Water in the Oven; Safety Instructions; Safety Block; Descale

Teka HLC 847 SC
56 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
17
EN
Residual water in the oven
To reduce the residual water in the oven, it is
recommended to insert a tray in the bottom
rack level. The condensation released from
the food begins to drip on the tray. The
remaining residual water can be easily dried
with a cloth. Take care the drip tray under the
door is dried after every use. A build-up of
liquid in this tray can quickly overflow and
damage the surrounding cupboards. It is
accessed through the opened door.
SAFETY BLOCK
This function can be selected at any time
while using the oven.
With the oven switched off. The child lock
will not allow the oven to be switched on
when the button is touched.
With the oven in use. If the feature is
activated while the oven is cooking or set to
delay, the keypad will not respond and it
will not be possible to use the dials or
change the cooking settings.
To activate this feature press and hold the
and buttons simultaneously until you
hear a beep and the symbol appears on
the screen. The control panel is now locked.
To deactivate this feature touch and hold
the and buttons simultaneously again
until you hear a beep and the symbol
disappears.
DESCALING PROCEDURE
1. Rotate the left dial to enter the Steam
menu.
2. Rotate the right dial until the Descaling
symbol appears on the right side of
the display.
3. Press the to start the descaling
function.
4. 0,5 remove the
water tank.
5. Pour 0.5 liters of an adequate descaling
solution into the water tank and put the
water tank back.
6. Press . The Descale cycle is initiated
and takes about 30 minutes.
8. The descaling process is silent and during
this process, the display shows the
percentage of the process and the
descaling symbol .
9. When the display shows and the oven
emits a beep, remove and empty the
water tank.
10. Fill the water tank with 0,5 liters of fresh
water and put the water tank back.
11. Close the panel The first rinsing cycle
starts.
12. When the display shows again and
the oven emits a new beep, remove and
empty the water tank.
13. Fill the water tank with 0.5l of cold water
and put the water tank back.

Table of Contents

Other manuals for Teka HLC 847 SC

Related product manuals