EN
22
plate to maximum power and try to
separate them.
Single Sensor Error :
If any of the sensors is active more
than 10 seconds, this error situation
occurs and error code”F1” is displayed.
roots. One of them is that there may
be an object (fork, knife…) on the any
of the sensor.
If you are sure that there is no any
object on the control unit, hob glass is
wiped with a dry cloth. If error
situation continue after this solution,
switch for 10 second
Plural Sensor Error:
If more than 2 sensors are sensed at
same time, this error situation occurs
and error code”F2” is displayed.
Potential root reasons of the
problem :
• There may be an object(pot…) or
from pot…) that cover more than 2
sensors
• Touch control location may
exposure more heat or steam
(from oven bottom of the hob…)
Please be sure that there is no any
all steam and heat sources. Then,hob
glass is wiped with a dry cloth. If error
situation continue after this solution,
switch for 10 second.
FC Error:
Fc message on the control and the
hot plates switch off: Overheating
in the electronics. Let thestove cool
for a while.
To Next Page
Loading...
