To Next PageTo Next Page
Need help?Do you have a question about the Tektronix 502 and is the answer not in the manual?
General| Type | Oscilloscope |
|---|---|
| Channels | 2 |
| Input Impedance | 1 MΩ |
| Maximum Input Voltage | 600 V (DC + Peak AC) |
| Input Capacitance | 47 pF |
| Power Supply | 115/230 V AC, 50/60 Hz |
| Display | CRT |
| Time Base | 0.5 µs/cm to 1 s/cm |
Describes sensitivity, response, and factors for vertical signal input.
Covers sweep rates, magnification, and triggering requirements.
Details line voltage needs and transformer connections.
Describes attenuator probe usage and compensation.
Explains how to stabilize sweep using trigger signals.
Guides on measuring AC and instantaneous voltages.
Explains how to measure time intervals using sweep calibration.
Describes determining waveform frequency from time interval.
Explains the purpose of each front-panel element.
Explains the regulated power supplies for instrument operation.
Provides guidance on component servicing.
Guides on diagnosing power supply issues.
Guides on resolving issues with sweep triggering.
Guides on resolving issues with sweep generation.
Guides on resolving issues related to the cathode ray tube.
Guides on resolving issues with vertical signal amplification.
Guides on resolving issues with horizontal signal amplification.
Details calibration steps for the power supply.
Details calibration steps for the internal calibrator.
Details calibration steps for the CRT and associated circuits.
