TDS 420A, TDS 430A, TDS 460A & TDS 510A User Manual
3–103
Saving and Recalling Setups
Your digitizing oscilloscope can store up to ten oscilloscope setups in internal
memory that you may later recall. This section describes how you save and recall
a setup and how you can recall the factory default setup.
To Save a Setup
To save the current setup of the digitizing oscilloscope:
1. Press SETUP
➞ Save Current Setup (main).
STOP. Before doing step 2 that follows, note that if you choose a setup location
labeled user, you will overwrite the user setup previously stored there.
2. To store a setup internally, choose one of the ten storage locations from the
side menu To Setup 1, To Setup 2, ... (see Figure 3–55). Now the current
setup is stored in that location.
3. To store a setup to disk, press To File. Then use the general purpose knob to
select the exact file from the resulting scrollbar list. Finally, press the
side-menu Save To Selected File to complete the operation.
NOTE. Setups are not transferable between different oscilloscope models or
software versions.
To Recall a Setup
To recall a setup stored internally, press SETUP ➞ Recall Saved Set-
up
(main) ➞ (Recall Setup 1, Recall Setup 2 ... (side).
To recall a setup stored on disk, press From File. Then use the general purpose
knob to select the exact file from the resulting scrollbar list. Finally, press Recall
From Selected File to complete the operation.
Recalling a setup does not change the menu that is currently displayed. If you
recall a setup that is labeled factory in the side menu, you recall the factory
setup. (The conventional method for recalling the factory setup is described
below.)
To Next Page
Loading...
