Tektronix TDS1002 Manual

Table of Contents
iv
TDS1000 and TDS2000 Series Digital Storage Oscilloscopes Service Manual
List of Figures
Figure 2--1: Routing the power cord and security cable 2--4..........
Figure 2--2: Installing and removing an extension module 2--5........
Figure 3--1: Module-level block diagram (two channel) 3--2..........
Figure 3--2: Module-level block diagram (four channel) 3--3..........
Figure 5--1: Adjustment setups 5--4...............................
Figure 6--1: Removing the rear feet 6--7...........................
Figure 6--2: Installing the rear feet 6--8............................
Figure 6--3: Removing and installing the flip feet 6--9................
Figure 6--4: Removing and installing the rear case 6--11..............
Figure 6--5: Aligning the oscilloscope rear case 6--13.................
Figure 6--6: Removing and installing the front feet 6--14..............
Figure 6--7: Removing the power supply module 6--15................
Figure 6--8: Installing the power supply module 6--16................
Figure 6--9: Removing and installing the internal assembly 6--17.......
Figure 6--10: Removing the display cable 6--19......................
Figure 6--11: Installing the display cable 6--20.......................
Figure 6--12: Removing and installing the front-panel cable 6--21.......
Figure 6--13: Main board removal 6--23............................
Figure 6--14: Removing the display module 6--24....................
Figure 6--15: Installing the display module 6--25.....................
Figure 6--16: Removing the front-panel module 6--26.................
Figure 6--17: Installing the front-panel module 6--27.................
Figure 6--18: Removing and installing the keypad 6--28...............
Figure 6--19: Oscilloscope troubleshooting tree (1 of 3) 6--32...........
Figure 6--20: Oscilloscope troubleshooting tree (2 of 3) 6--33...........
Figure 6--21: Oscilloscope troubleshooting tree (3 of 3) 6--34...........
Figure 6--22: Measuring the backlight voltage 6--39..................
Figure 7--1: TDS1000 and TDS2000 series block diagram 7--2........
Figure 8--1: Exploded diagram 8--7...............................

Tektronix TDS1002 Specifications

General

Bandwidth	60 MHz
Channels	2
Sample Rate	1 GS/s
Record Length	2.5k points
Vertical Sensitivity	2 mV/div to 5 V/div
Vertical Resolution	8 bits
Display Resolution	320 x 240 pixels
Display	5.7 inch monochrome LCD
Trigger Modes	Video, Edge
Connectivity	USB 2.0
Weight	2.0 kg
Input Impedance	1 MΩ
Power Supply	100 to 240 VAC, 45 to 440 Hz