Index
THS710A, THS720A, THS730A & THS720P User Manual
Index–5
R
readouts
cursors, 3–12
DMM reading, 3–41, 3–50
measurements, 3–19, 3–53
power measurements, 3–20
time base, 3–52
trigger, 3–52
waveform, 3–19, 3–51
reference lead, 2–14
reference waveforms, 3–71
Rel D, 3–7
reset
data logger, 3–42
statistics, 3–38
resistance, 2–18
rise time measurement, 3–36
RMS measurement, 3–36
roll mode, 3–28
RS-232
adapters, C–2
cable, 3–24, C–2
hard copy, 3–22
pinout, A–16
port location, 1–4
setting up, 3–64
troubleshooting, 3–64
RUN/STOP button, 3–26
S
sample, 3–3
SAVE/RECALL button, 2–4, 3–45
saved information, to prevent loss,
1–5
SCOPE button, 3–48
scope mode
features, 1–2
how to use, 2–8
SEC/DIV rocker
meter mode, 3–30
scope mode, 3–28
selected waveform
how to select, 3–68
indicator, 3–50
self test, 3–67
SET LEVEL TO 50% button, 2–7
setups
factory setup description, B–1
saving and recalling, 3–45
signal path compensation, 2–11,
3–66
single acquisition sequence, 3–6,
3–26
specifications, A–1
standby timeout, 3–65
statistics
readout location, 3–41
resetting, 3–26
selecting, 3–37
status, 3–49
STBY. See ON/STBY
T
T symbol, 3–27, 3–29
Tek Secure, 3–63
THD, calculation method, 3–17,
A–8
tilt stand, 1–8
time base, 3–29
time-out, 3–65
TOGGLE button, 3–11
TRIGGER MENU button, 2–5,
3–54
trigger position, 3–29
trigger status, 3–49
To Next Page
Loading...
