Telect, Inc. • USA +1.509.926.6000 • Mexico +52.33.3836.37.52
www.telect.com • © 2010 Telect, Inc., All Rights Reserved, 129094 A0.1
Page 1
ELF RJ45C to RJ45C Patch Module
Model ELF-9716-1900
Installation Guide
1.1 Overview
Figure 1 - Model ELF-9716-1900
Telect’s ELF family of modules features small-
factor “Elf-sized” units ideally suited for
deployment terminations at the network’s edge.
Telect’s ELF RJ45C to RJ45C Patch Module
pro
vides patching between 16, shielded RJ45C
connectors on the rear and male RJ45C
connectors inserted in corresponding shielded
RJ45C connectors on the front. Each patch
module includes a tie bar on the front, with the
ELF chassis (Telect Model ELF-0000-2400)
providing tie bar anchorage for the rear.
1.2 Inspection
Please read these instructions carefully before beginning installation. If you need assistance, call
Technical Support at 1-888-821-4856 (domestic calls), or 509-921-6161 (Option 2), or email us at
getinfo@telect.com.
Inspect equipment after unpacking and compare it to the packing list.
Immediately report any shipping damage, defects, or missing parts to Telect at 1-800-551-4567.
Kee
p all documentation that comes with your shipment.
Telect is not liable for shipping damage. If the pro
duct is damaged, notify the carrier and call
Telect’s Customer Service Department at 1-800-551-4567 (domestic only) or 1-509-926-6000 for
further recourse.
NOTE: For service or warra
nty information, please visit the telect.com website, or email inquiries
to getinfo@Telect.com and click on the “Support” tab, or phone us at 800-551-4567 (domestic
only) or 509-926-6000.
1.3 Installation
ALERT! Only qualified technicians may install and maintain this product.
To Next Page
Need help?
General
