Need help?Do you have a question about the Teledyne OLCT 60 and is the answer not in the manual?
General| Output Signal | 4-20 mA |
|---|---|
| Operating Humidity | 0-99% RH (non-condensing) |
| Ingress Protection | IP66 |
| Gases Detected | Toxic gases, Combustible gases, Oxygen |
| Communication Protocol | HART, Modbus |
| Operating Temperature | -40°C to +70°C (-40°F to +158°F) |
| Power Supply | 24 VDC |
| Enclosure | Stainless steel |
| Certifications | ATEX, IECEx |
Explains the sensor's function and lists the detector's internal components.
Details the detector's external appearance, display, LEDs, and sensor type differences.
Describes internal components and identification labels on the detector.
Explains startup sequences, normal operation, and fault mode displays.
Covers installation standards, operating zones, and necessary tools.
Provides guidelines for optimal detector placement and mounting orientation.
Details power requirements, wiring, grounding, and cable selection.
Outlines usage limitations and the detector's output signal characteristics.
Explains initial checks and lists required equipment for commissioning.
Details prior checks, powering up, and sensor stabilization periods.
Covers display modes, zero, and sensitivity verification procedures.
Defines the frequency of tests and periodic maintenance tasks.
Lists common detector errors and faults with their causes and solutions.
Guides on replacing the sensor module and initializing the new unit.
Provides step-by-step instructions for zeroing and sensitivity adjustment.
Details how to check the output current and use the self-test menu.
Presents optional accessories for the OLCT 60 detector.
Lists available sensor blocks for different ATEX certifications.
States compliance with ATEX and EMC directives and applicable standards.
Provides detailed diagrams and measurements of the detector.
Lists technical data for the complete detector and individual sensors.
Covers instructions for explosive atmospheres, warnings, and dust precautions.
Details thread types, static risk, limitations, and overrange conditions.
Explains low oxygen operation, calibration advice, functional safety, and reliability.
Details ATEX markings and classifications for different detector models.
Lists communication errors and material faults with their codes and descriptions.
To Next Page
