25
5. CLEANING AND MAINTENANCE
To remove the oven door
Tightening
latch
Recessed
support
1
2
3
To remove the oven door
Open the oven door (1).
Open the tightening latch up to the final
position (2).
Close the door until it is almost completely
closed as shown in the third diagram and
remove the door by pulling it.
Make sure that the embedded supports are
well positioned on the hinge support as shown in
the second diagram.
the door is done
Make sure the
tightening latches are well refitted.
:
•
•
•
Refitting by reversing the
procedure explained above.
!
Cleaning gas burners
Remove (Figure 16).
Clean them with soapy water
Rinse and dry with a soft cloth (do not leave them wet)
After cleaning, make sure that you re-assemble the parts correctly.
Do not clean any part of the cooktop with metal sponge. It causes the surface to be scratched.
The upper surfaces of burner caps may deteriorate over time due to their use and the burner
flames.
When cleaning the cooktop plate, make sure that no water flows inside the burners to
the injectors.
•
•
•
•
•
•
•
the burner cap and burner crown.
avoid
blocking
To Next Page
Loading...