INITIALIZATION
Introduction
The Plixus system always works with seats. A seat is a conceptual name for a unit or a group of units which
are combined on that seat. By default this is a one-to-one mapping, so every unit has one seat. However,
there can be more advanced cases where units are manually combined on a seat. During initialization you
can assigns units to seats.
Figure 1-59 Initialization page
1. In Initialization on the left side of the page you select the mode of initialization.
2. System status shows the status of all units, you can see the amount of initialized, faulty and
not initialized units. Faulty units are units that were initialized, but are now missing. Not initialized
units are connected, but not yet initialized.
3. In the Advanced settings you can define the maximum number of desk per booth (for
interpretation).
4. The Initialization list on the right side shows all unitialized units, per unit you can see the
following information:
a. Seat number: position of the unit in the meeting room
b. Unit type
c. Chairman capabilities: can unit acts as chairperson, indicated by star icon.
INITIALIZATION 112
To Next Page
Loading...
