Televic Plixus AE-R - Detach Bottom

If you use the fixed configuration and place the cables through the bottom opening into the table, use the
side panels depicted in B as shown in the figure below.
A.
B.
Figure 1-56 How to mount the side panels of the Nameplate depending on the cabling. A. Standalone cabling,
B. fixed cabling
Detach Bottom
To detach the nameplate from the mounting bracket (and bottom plate), use a flat screw driver or
something similar. Insert the screw driver into the rectangular opening on the side of the nameplate base
and press down.
MO UNT THE NAMEPL ATE 98