When no microphones are active, then the following synchronization will be received:
%S00000113
When the camera control system should reset itself to its start position, then the following
message will be received: %R0052
When all microphones are deactivated simultaneously, then the following message is received:
%V00000116
COMMANDS FOR TLVCAM2 PROTOCOL (PHILIPS)
All commands sent by this protocol start with a ‘$’ sign or ‘&’ and commands are terminated with a CR
(0xd) and LF(0xa).
The microphone of a delegate is activated: $1{Microphone number (4)}<CR><LF>
The microphone of a delegate is deactivated: $2{Microphone number (4)}<CR><LF>
All active microphones are deactivated and the camera control should reset itself to a neutral
starting position: &30000<CR><LF>
All active microphones are deactivated simultaneously: &30000<CR><LF>
EXAMPLES
If the president microphone is activated, and the president microphone has the number ‘0001’
then the following message is sent: $10001<CR><LF>
When the president microphone is deactivated, then the following message is sent:
$20001<CR><LF>
If a delegate microphone is activated, and that delegate microphone has the number ‘0003’
then the following message is sent: $10003<CR><LF>.
When the delegate microphone is deactivated, then the following message is sent:
$20003<CR><LF>
When the camera control system should reset itself to its start position, then the following
message will be received: &30000<CR><LF>
When all microphones are deactivated simultaneously, then the following message is received:
&30000<CR><LF>
REST API
The Plixus Core API provides a subset of commands that are available on the CoCon API. The Plixus Core
API has the same communication protocol and command structure as the CoCon API which allows third-
NETWORK SETTING S 13 9
To Next Page
Loading...
