COMPONENTS
General Overview
Figure 1-2 Plixus architecture diagram with example setup
The Plixus architecture allows for a mix & match of components: from flushmount devices over multimedia
units and interpreter desk to PTZ cameras and third-party Dante™-enabled applications.
A typical setup consists of the following components:
A central engine (multimedia or audio-only)
CAT 5e network cables
Depending on the size of the network: one or more power supplies.
Depending on the size of the network: one or more network extenders. Each network extender
powers a separate branch. It permits 4 branches or 2 loops.
CoCon management software to manage every aspect of the meeting
T-Rex recording software to record audio
CO MPO NENTS 21
To Next Page
Loading...
