Telit Wireless Solutions ME910C1-WW - Page 170






AT Commands Reference Guide
80529ST10815A Rev.2– 2017-09-14

ReproductionforbiddenwithoutTelitCommunicationsS.p.A.writtenauthorization‐AllRightsReserved  page170of233

#SSENDEXT - Send Data In Command Mode extended
<bytestosend>
Example
Open the socket in command mode:
at#sd=1,0,<port>,"IP address",0,0,1
OK
Give the command specifying total number of bytes as second
Parameter:
at#ssendext=1,256
> .............................. ; // Terminal echo of bytes sent is displayed here
OK
All possible bytes (from 0x00 to 0xFF) are sent on the socket as generic bytes.