EcoInsight I, O & M Guide
Telkonet, Inc.
For Use with Firmware Version 2.x
20800 Swenson Drive, Suite 175
High Voltage Installation
Waukesha, WI 53186
Revision 4.2
(414) 302-2299
Page 13
www.telkonet.com
Figure 11: Metal Pins-Use Care
Step 19 Return the electrical circuit to operation. Remove all lockouts or tags from the circuit
breaker and enable any disconnects.
Step 20 Verify the EcoInsight thermostat display is active.
Step 21 Test all components to make sure that you can engage both the heat and air conditioning,
and all supported fan settings (high, low, etc.). Wiring is complete.
Step 22 Once the thermostat has been snapped onto the back plate, use a hex wrench to insert
the safety screw.
To Next Page
Loading...
