EcoInsight I, O & M Guide
Telkonet, Inc.
For Use with Firmware Version 2.x
20800 Swenson Drive, Suite 175
Low Voltage Installation
Waukesha, WI 53186
Revision 4.2
(414) 302-2299
Page 23
www.telkonet.com
4. SS6000-Wi has WiFi header for WiFi-enabled thermostats
Figure 23: Internal View of EcoInsight
Relay Configuration
The thermostat comes with a default relay configuration, which sets the functions of each pin. This default can
be changed to one of several alternate relay configurations, which are stored in the memory of the thermostat.
To change your thermostat relay configuration, see Table 6, specifically command #2.
Speed Configurations
The EcoInsight will ship with a default speed configuration that matches the default relay configuration. The
speed configuration controls the timing of shifts between both fan speeds and stages of HVAC for compressor
based systems. The speed configuration will have a 3 minute safety delay between compressor cycles and upon
power up. The EcoInsight also has several alternative embedded speed configurations. See Table 6:
Maintenance Menu Functions, specifically command #3.
J5 Connector
The functions of the J5 Connector will vary based on the device model.
To Next Page
Loading...
