1.
To select the Stadiametric Rangefinder function, enter the Quick
Menu by briefly pressing the MENU (11)button.
2.
Press the MENU (11)buttonbriefly to select the icon
Image not found or type unknown
.
3.
You will see on the display: measurement bars, icons of three reference
objects and respective distances for the three objects.
4.
Position the lower fixed bar under the object being ranged.
5.
By pressing the UP (10)/DOWN (12)buttons, move the upper
horizontal bar relative to the lower fixed bar until the object fits entirely
between the two bars. The distance to the object is automatically
recalculated as you move the upper line.
6.
Exit the rangefinder mode with a long press of the MENU (11)button
or wait 10 seconds to exit automatically.
Notes:
There are three predefined values for the reference objects: Hare - 0.3
m height, Boar - 0.7 m height, Deer - 1.7 m height.
Before it appears on the display, a measured distance value is rounded
up to 5m for larger values and rounded down to 1m for smaller values.
To select the unit of measurement (Meters or Yards), go to theGeneral
Settings
Image not found or type unknown
menu item =>Units of Measure submenu.
To Next Page
Loading...
