3.
Your device will be detected by the computer automatically; no drivers
need to be installed.
4.
Two connection modes will appear on the display: Power and Memory
Card(external storage device).
5.
Select the connection mode with the UP (10)/DOWN (12)buttons.
6.
Confirm the selection with a short press of the MENU (11) button.
Power
In this mode, a PC/laptop is used as an external power supply. The
status bar shows the icon . The device continues operating and all
functions are available.
Battery recharge feasibility depends on your computer's USB port.
When the USB is disconnected from the device when in the Power
mode, the device keeps operating with the Battery Pack if it is available
and sufficiently charged.
Memory Card (external memory)
In this mode the device is detected by the computer as a flash card. This
mode is designed for work with the files saved in the device's memory.
The device's functions are not available in this mode; the device turns
off automatically.
If video recording was in progress when the connection was made,
recording stops and the video is saved.
If the device is in Memory Card mode and is disconnected from USB,
the device will remain on.
To Next Page
Loading...
