Programming devices to Optik TV
TM
© 2012 TELUS. 08/12
Congratulations – you’re done!
Troubleshooting: If the programming does not work properly,
please refer to the FAQ’s at telus.com/remotefaq.
Programming your TV
*
Selecting "Other" will search for all other TV brands and may take up to 15 minutes to generate codes.
1
Tap the
button until the red TV light on your remote flashes, as shown in
the picture on the right.
2
Press and hold the button for 3 seconds, until the TV light flashes twice.
3
Refer to the table on the right. Enter the code for your TV brand.
The light will flash twice.
4
Press and hold the
button. When your TV switches off, remove your
finger from the
button.
5
Press . The red TV light will flash twice.
6
Press the
button again to switch your TV back on.
7
Tap the button until the green OPTIK light is illuminated at the top
of your remote.
That’s all there is to it. Now, you can turn your TV and digital box on and off
simultaneously by pressing the
button on your remote.
Remote Control
Before you start to program your remote control, make sure your TV is switched on.
DVD, BluRay and Audio Auxiliary Devices
To learn how to program your remote to control these devices,
please visit telus.com/programtvdevices.
Quick tips
1
Back/Exit: a. Tap to go back. b. Press and hold to exit.
2
If you’re using Xbox 360
®
as a set top box, your remote has been pre-programmed
to control it. To control your Xbox 360
®
, make sure you are in AUX mode.
Mode & Power
Buttons
Funai 11
Insignia 21
LG 15
Panasonic 13
Philips 19
RCA 20
Samsung 18
Sanyo 12
Sharp 14
Sony 17
Toshiba 16
Vizio 10
Other*
29
Codes for
TV Brand
OK Button
To Next Page
Need help?
General