Well-Known Service Port: Select the well-
known services as DNS, FTP from the drop-down
menu to add to the configured one above.
Add: Add the selected well-known port to the
policy ID.
For example:
You can establish a WEB server at the computer with
the IP address of 192.168.0.10 in LAN and the server
use the port of 80. If you can visit the WEB server in
WAN when you enter http://x.x.x.x:40, you can enter
40 at the “WAN Ports “on this page and enter 80 at
the “LAN Ports”. “LAN IP” set 192.168.0.10. “Protocol”
selects all. It takes effect after saving the settings.
NOTE: If you set the virtual server of the service
port as 80, you must set the Web management
port on Remote Web Management page to be
any value except 80 such as 8080. Otherwise,
there will be a conflict to disable the virtual
server.
9.2 Port Range Forwarding
This section deals with the port range forwarding
mainly. The Port Range Forwarding allows you to set
up a range of public services such as web servers, ftp,
e-mail and other specialized Internet applications to
To Next Page
Loading...
