Tenda 4G680 - Configure the QoS function


48

10.2 ConfiguretheQoSfunction
TheQoSfunctionallowsyoutoprioritizetrafficofcertainclients,sothatmoreimportanttraffic
canpassthroughfirst.

Parameter Description
Upstreambandwidth Itspecifiesthebandwidthassignedtothelocalhostsspecifiedintherules.
LocalIP ItspecifiestheIPaddressofthelocalhostthatistobeassignedpriority.
Ports ItspecifiestheportusedbythelocalhosttoaccesstheremoteIP.
RemoteIP ItspecifiestheIPaddresstobeaccessedwithpriority.
Ports ItspecifiestheportusedbytheremoteIPtobeaccessed.
Enable Itisusedtoenableordisablethecorrespondingrules.

ProceduresforaddingnewQoSrules:
Step1 Startawebbrowseronthedeviceconnectedtotherouter,andvisit192.168.0.1.
Step2 ChooseSystem> QoS.
Step3 SelectEnableQoSPacketFilter.
Step4 EnterthebandwidthlimitforUpstreambandwidth.
Step5 ClickAdd,entertheLocalIPandPortsofacertainprioritizedclientundertheLANofthe
router,andentertheRemoteIPandPorts,andselectEnable.
Step6 ClickOKandApply.
‐‐‐End
Afterthesetting,thedataexchangebetweenthespecifiedlocalIPaddressandremoteIPaddress
willbeforwardedinpriority.