Tenda N300 Wi-Fi xPON ONT - Page 67

Services
59
Parameter description
Parameter
Description
Outgoing Default
Action
They specify the default action for the outgoing or incoming data.
⚫
Deny: Denies traffic which does not match the filter rule in the Current Filter Table.
⚫
Allow: Allows traffic which does not match the filter rule in the Current Filter
Table.
Incoming Default
Action
Direction
It specifies the forwarding direction of data to be filtered.
Source MAC Address
They specify the source and destination MAC addresses of data packets.
You can only enter one source MAC address and destination MAC address in one
MAC filtering rule.
The MAC address cannot contain any special characters. An example in the correct
format is cc3a61711b6e.
Destination MAC
Address
Rule Action
It specifies whether to deny or allow the data to pass through.
⚫
Deny: Packets that comply with the rule are denied, while others are treated with
the default action.
⚫
Allow: Only packets that comply with the rule are allowed, while others are treated
with the default action.
Allow only specified devices to access the internet
Scenario: The Wi-Fi network at your home is misused by unknown users sometimes.
Goal: Only allow certain devices of family members to access the internet.
Solution: You can configure the MAC address filter function to reach the goal.