LED indicator status
Solid green Connected to the internet.
Solid yellow Networking succeeds. Fair connection quality.
Solid red Networking succeeds. Poor connection quality.
Blinking green slowly
Connecting to other nodes or waiting to
connect to other nodes.
Blinking green fast Networking by MESH button.
Blinking red slowly Failed to connect to the internet.
Description
After the device is powered on for about 40 seconds, the system completes
startup. The status of the LED indicator is shown in the following table.
LED indicator status
− Ensure that the computer is connected to the LAN port of the
node properly using an Ethernet cable.
− Ensure that the computer is set to obtain an IP address automatically
and obtain DNS server address automatically.
If the problem persists, please reset the node and try again.
Reset method: When the device completes startup, hold down the RESET
button using a needle-like item (such as a pin) for about 8
seconds, and then release it when the LED indicator blinks
red fast. The device is reset successfully.
Q4: The device failed to be detected by the Tenda WiFi app upon my
first time using the device, what should I do?
A4: Try the following solutions:
1. Ensure that your mobile phone is connected to the default WiFi
network of the device.
2. Ensure that the network permissions of Tenda WiFi app is
enabled. You can tap Settings > Tenda WiFi to enable it.
If the problem persists, please reset the node and try again.
To Next Page
Loading...
Need help?
General
