ON--BOARD BATTERY CHARGER ERROR CODES
DISPLAY CODE
FAULT SOLUTION
bat Loose or damaged battery cable Check battery cable connections.
Battery exceeded maximum voltage level. No action necessary.
E01 Exceeded maximum battery voltage allowed. No action necessary.
E02 Safety thermostat exceeded maximum internal
temperature.
Check if the charger vents are obstructed.
E03 Exceeded maximum time for charging phase
leaving the batteries undercharged due to a
sulfated or faulty battery.
Repeat the charging cycle and if the error
code E03 reappears check battery or
replace it.
SCt Safety timer exceeded maximum charging
time. Interrupts charging cycle.
Replace battery.
Srt Possible internal short circuit. Contact Service Center.
T5 –Maintenance
(Page 3 of 15)
T5 9002333 REV.02 (07-06) 9
To Next Page
Loading...
