Tennant T5 - Display Software Revision Mode

Rev 00
One Step Button
Indicates Month (One’s) Indicates the Month (Ten’s)
Indicates the Day (Ten’s)
Indicates the Year (One’s) Indicates the Day (One’s)
Indicates the Year (Ten’s)
Holding the One Step button on Power-up puts you into the software revision display mode. The number of blinks by the Down Pressure and Water level LED’s represents the software revision.
1. The Highest Pressure (ten’s) & water level (one’s) numbers blinking together represents the month. 2. The Middle Pressure (ten’s) & water level (one’s) numbers blinking together represents the day. 3. The Low Pressure (ten’s) & water level (one’s) numbers blinking together represents the year.
No blinking of an LED means zero. For example if the high pressure LED does not blink and the high water LED blinks six times, that means the month is JUNE. Also if the Middle Pressure LED blinks twice and the Middle water blinks once, that means the day is the 21
st
.
Note: The software revision LED will continue to blink until the machine is turned off.
P
u
s
h
&
H
o
l
d
,
T
u
r
nK
e
y
S
w
i
t
c
h
O
N
T5 – Display Software Revision Mode
(Page 1 of 2)
52 T5 9002333 REV.02 (07-06)
E