Rev 00
Indicates Supervisor Lockout active
when LED is illuminated.
In Supervisor Mode the machine will function normally, but the Scrub Head Down Pressure, Solution Flow and FaST controls are locked out from the
operator. Scrub Head Down Pressure, Solution Flow and FaST settings may be preset and locked into the machine. Once the setting is locked into memory
it cannot be changed until the machine is toggled back out of Supervisor Mode.
1. Activate Supervisor Mode by holding both the Increase Down Pressure (+) button and the Increase Water (+) button down simultaneously
during power up until battery LED 1 or 3 blinks four times.
Battery LED 3 (Green) indicates that supervisor mode has been enabled. This will lock in the current Scrub Head Down Pressure, Solution
Flow, and FaST settings.
Battery LED 1 (Red) indicates that supervisor mode has been disabled. This will unlock the current Scrub Head Down Pressure, Solution Flow,
and FaST settings, and allow the settings to be changed in Normal Mode.
2. Cycle the key switch to return to Normal Mode and observe Fault LED #3 (below padlock symbol).
Fault LED 3 on indicates Supervisor Mode enabled. The LED will flash if a locked out button is pressed.
Fault LED 3 off indicates Supervisor Mode disabled.
P
u
s
h
&H
o
l
d
,
T
u
rn
K
e
y
S
w
i
t
c
h
O
N
P
u
s
h
&
H
o
l
d,
Tu
r
n
K
e
y
Sw
i
t
ch
ON
T5 –Supervisor Mode
T5 9002333 REV.02 (07-06) 61
E
To Next Page
Loading...
