Page3of4
KIT NO. 9003295 (120v), 9003296 (230v)
On--Board Charger Kit
INSTALLATION INSTRUCTIONS -- Continued
9003301 Rev. 00 (01--07) Tennant Company Customer Service: (800) 553--8033 or (763) 513--2850
Attach red wire from charger
Attach black wire from charger
Fig. 8
7. Re--attach squeegee lift bracket to machine.
8. Plug the power cord into the charger. Secure
thecordtothemachineusingtheclamp,
mounting screw and flat washer provided in
the kit. Use a small amount of blue adhesive
on the screw threads (Figure 9).
Use 26395--2 Clamp, 609062
Screw and 01684 Washer
Fig. 9
9. Attach the cord hooks to the new side panel
as shown (Figure 10).
Use (2) each 610609 Hook,
1024965 Bolt, 611311 Spring,
01684 Washer , 08712 Nut
Rotomold
Fig. 10
10. Attach the new side panel to the machine in
place of the old one. Tuck the red and black
charger wires into the pocket on the inside of
the cover to prevent them from hanging
loose. Route the charger power cord through
slot on bottom of side panel and neatly wrap
the cord on the cord hooks when not in use
(Figure 11).
Fig. 11
11. Apply the new battery label to the wall of the
battery compartment in the location shown
(Figure 12).
Rear batteries not
shown for clarity
Fig. 12
12. Apply the new T5 side label from the kit, and
re --install the batteries and right side panel.
Re --connect positive and negative battery
cables.
Apply new parking brake label near the park-
ing brake (Europe machine only)
13. Refer to your machine’s operator manual for
charger instructions.
To Next Page
Loading...
