Tennant T5 - Page 12

OPERATION
12
Tennant T5 (06- 16)
3. Set the yellow spring clips to the open position to
make brush installation easier. Press clips down
and outward to set (Figure 10).
FIG. 10
4. Align the pad driver or brush under the motor hub
and push it upward to engage hub (Figure 11).
FIG. 11
5. To remove the pad driver or brush, raise the scrub
head and push the pad release plunger downward
(Figure 12).
FIG. 12
6. Check the scrub head to ensure that it is properly
adjusted (See ADJUSTING SCRUB HEAD
BRUSHES).
Cylindrical Brush Model:
1. Raise scrub head off the floor and remove key.
2. Remove idler plate from scrub head by pressing
the spring tab downward (Figure 13).
FIG. 13
3. Attach idler plate to the brush end that has the
double row of bristles (Figure 14). Install brush.
Double row of
bristles
FIG. 14
4. Check the brushes to ensure they are properly
adjusted (See ADJUSTING SCRUB HEAD
BRUSHES).