OPERATION
Tennant T5 (06- 15)
17
ec-H2O Models
(ec-H2O models manufactured before ec-H2O
NanoClean)
If an alarm sounds and the ec- H2O system indicator
light begins to blink red, the ec- H2O module must be
flushed to resume ec- H2O operation (See ec- H2O
MODULE FLUSH PROCEDURE) (Figure 31).
NOTE: When the alarm sounds and the light blinks red,
the machine will bypass the ec- H2O system. To
continue scrubbing, turn the ec- H2O switch off and
change over to conventional scrubbing.
ATTENTION: (ec- H2O model) Do not allow solution
tank to run dry. ec- H2O module failure may result
if operated without water for an extended period.
FIG. 31
ec- H2O SYSTEM
INDICATOR LIGHT CODE
CONDITION
Solid green Normal operation
Blinking red Flush ec- H2O module
Solid red Contact Service Center
BATTERY CHARGE LEVEL INDICATOR
The battery charge level indicator displays the charge
level of the batteries (Figure 32). When the batteries
are fully charged, all five indicator lights will glow. As
the batteries discharge, the indicator lights will begin to
go out from right to left.
When the discharge level reaches the red light, the
operator will have approximately one minute to
continue scrubbing. When the red light begins to flash
the scrubbing functions will automatically shut off to
alert the operator to recharge the batteries. By pressing
the 1- STEP Scrub button, when the red light is
flashing, the operator will get an additional minute of
scrubbing.
FIG. 32
To Next Page
Loading...
