Tennant T5 - Draining and Cleaning Tanks

OPERATION
Tennant T5 (12- 13)
19
2. Lower the squeegee to activate the vacuum motor
(Figure 38).
FIG. 38
3. Squeeze trigger to activate solution. Use brush for
scrubbing and squeegee for pickup (Figure 39).
W ARNING: Flammable materials or reactive
metals can cause an explosion or fire. Do not
pickup.
FIG. 39
4. After scrubbing, turn off the wand switch and
squeeze the trigger for five seconds to relieve the
water pressure before disconnecting the solution
hose.
DRAINING AND CLEANING TANKS
After each use, the tanks should be drained and cleaned.
FOR SAFETY: Before leaving or servicing machine,
stop on level surface, set parking brake if
equipped, turn off machine and remove key.
DRAINING RECOVER Y TANK
1. T ransport machine to disposal area and turn key
switch off.
2. While holding the drain hose upward, remove the
cap and lower hose to drain (Figure 40).
FIG. 40
3. After draining, open the recovery tank and clean
out the tank (Figure 41).
FIG. 41
4. Clean the float shut-off screen and debris tray
located in the recovery tank (Figure 42).
FIG. 42