Tennant T5 - Using the On-Board Battery Charger

OPERATION
22
Tennant T5 (NIL)
USING THE ON- BOARD BATTERY CHARGER
IMPORTANT: Before charging, make sure that the
charger setting is properly set for your battery type
(See ON- BOARD CHARGER SETTINGS).
1. T ransport the machine to a well- ventilated area.
2. Park the machine on a flat, dry surface. Turn the
key off and set the parking brake, if equipped.
FOR SAFETY: Before leaving or servicing machine,
stop on level surface, set parking brake if
equipped, turn off machine and remove key.
3. If charging wet (lead acid) batteries check the fluid
level before charging (See BATTERY
MAINTENANCE).
4. Prop up the recovery tank for ventilation
(Figure 48).
FIG. 48
5. Connect the charger’s AC power supply cord into a
properly grounded receptacle (Figure 49).
NOTE: The machine will not operate when charging.
FIG. 49