EasyManua.ls Logo

Tensa Outdoor Tensa4 Setup

Default Icon
4 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Tensa4 Setup
Grasp the outer tube and pull slightly. Line up the holes on the adjacent tube and pull until the
button engages. Repeat until all sections are extended. See Fig. 1
Connect the 4-section pole to the 3-section pole at the open ends. Repeat until you have 4 long
poles. See Fig. 2
Lay all four 7-section poles next to each other as shown, and connect 2 poles to each end of the
baseline. Then connect the other end of the poles to the ridgeline similarly. This should make a
floppy diamond, not two sets of 2 poles. See Fig 3 and Fig 4a - c

Other manuals for Tensa Outdoor Tensa4

Question and Answer IconNeed help?

Do you have a question about the Tensa Outdoor Tensa4 and is the answer not in the manual?

Tensa Outdoor Tensa4 Specifications

General IconGeneral
BrandTensa Outdoor
ModelTensa4
CategoryHammocks
LanguageEnglish