Need help?Do you have a question about the Teseq NSG 3040 and is the answer not in the manual?
Explains symbols used in the manual for clarity and safety.
Overview of the NSG 3040 as a multifunction EMC test system.
Simulates high voltage/frequency pulses from inductive loads.
Simulates lightning strike interference on power supply.
Simulates voltage dips and interruptions.
Simulates magnetic fields from power lines and pulses.
Operator training, proper use, and responsibility for radiated interference.
Requirements for safe installation, grounding, and environment.
Safety measures during test execution, access control, and EUT handling.
Dangers related to high voltages, arcing, and EUT behavior.
Procedures for unpacking, checking for damage, and verifying contents.
Instructions for connecting power and preparing the system.
Connecting to ground reference plane and mounting options.
Identifies touch screen, LEDs, outputs, and controls on the front panel.
Details Ethernet, system interface, and power inputs on the rear panel.
Describes the 4-pin connector for EUT power and wiring functions.
Overview of the main menu and available test selections.
Access to GENERAL, EQUIPMENT, COMMUNICATION, MONITORING settings.
Settings for beeper, interlock action, and expert mode.
Configuring network settings (IP, SubNet, Gateway, Port).
Viewing EUT voltage/frequency and test action on EUT fail.
Setting test parameters via red and bottom bars.
Procedures for loading user tests and saving current configurations.
Overview of included standard tests based on IEC standards.
Setting voltage, frequency, phase, and coupling for burst tests.
Setting parameters for surge pulses, impedance, and coupling.
Configuring tests for power supply variations.
How the interlock circuit ensures safety and system operation.
Output signals for oscilloscope triggering and phase synchronization.
Pulse enable, EUT fail, and EUT power off control inputs.
Technical specifications and applications of the integrated CDN 3041.
Description of the high-end IEC configuration.
Details on customer-specific configurations and modularity.
Components of MF and MF-ERC mainframes and associated modules.
Remote control and exclusive pulse output versions.
Specific models for Dips/Variations and Oscillatory Wave tests.
Guidelines for cleaning and general maintenance procedures.
Steps to verify system operation and calibration importance.
Remote control software for test setup and execution.
Networks for multi-phase testing, surge, and data lines.
Automatic variacs and step transformers for PQT.
Accessories for generating magnetic fields at mains frequency and pulsed.
Adapter for interconnecting surge generator and loop antennas.
Data line coupling clamps for EFT/burst tests.
Probes and current probes for verification and measurement.
Various connection components for system setup.
Trolley and rack mounting brackets for system placement.
To Next Page
General