Bulb replacement
9-11Roadside emergencies
Trunk light
To remove the bulb:
1. Using the screwdriver supplied in the
toolkit, remove the two screws
securing the light unit to the inside of
the trunk.
2. Withdraw the light unit from the trunk
and disconnect the two connectors.
3. Remove the lens from the light.
4. Spring the bulb holder clips apart to
release the bulb.
To install the new bulb, reverse the above
procedure.
License plate light
To remove the bulb:
1. Using the screwdriver supplied in the
toolkit, remove the two screws
securing the light unit to the rear
bumper.
2. Withdraw the light unit from the
bumper and disconnect the two
connectors.
3. Remove the lens from the light.
4. Spring the bulb holder clips apart to
release the bulb.
To install the new bulb, reverse the above
steps.
Headlight low beam
To remove the bulb:
1. Remove the two bolts securing the
headlight access panel to the wheel
arch liner.
2. Release and remove the access panel.
3. Remove the cover from the rear of the
headlight.
4. Rotate the bulb holder 60°
counterclockwise and withdraw the
bulb from the headlight.
5. Disconnect the connector from the
bulb holder.
To install the new bulb, reverse the above
procedure. Ensure that the bulb holder is
correctly located and locked into the rear
of the headlight.
TR0171
TR0172
TR0260
To Next Page
Loading...
