Car Carrier Loading Procedure:
7
Front Eyebolt Location
These vehicles are equipped with a towing eyebolt lo-
catedunderthefrontcargoarea’soorliner.Itscrews
into a receiver in the driver’s front bumper.
• Remove the eyebolt receiver cover from the loca-
tions shown below.
• Fully screw the towing eyebolt in, by turning it
clockwise until secure.
NOTE: This towing point is not designed for recovery
operations.
NOTE: TheeyeboltreceivercoverontheMODEL3
has a cable zip-tied to it. Ensure the cover is secured so
it is not lost or damaged during transport. If possible,
remove the assembly completely from the bumper and
stow the cover in the vehicle.
NOTE: The eyebolt receiver cover on the MODEL S
& X are corner plastic pieces located in the lower grille
area of the front bumper. Use caution not to damage
them when removing.
It is highly recommended to attach a second-
ary backup nylon strap to the vehicle. This is a
precaution in the event the eyebolt attachment
should fail. Using a short nylon strap, wrap
the lower control arm and attach the other end
to the winch line hook. This strap will remain
slack and will only be utilized as a securing
device if the eyebolt attachment fails.
Secondary Safety Strap:
To Next Page
Loading...
