Overview
The touchscreen displays the status of Cybertruck at all times. What you see depends on whether the vehicle is:
• Parked (see Touchscreen on page 7).
•
Driving (see Driving Status on page 17).
•
Charging (see Charging Status on page 169).
When Cybertruck is parked, the status area shows the drive mode, estimated range, suspension height and available
adjustments, and an exterior view of the vehicle with buttons you can touch to open the tonneau cover, tailgate,
powered frunk, and charge port door.
When you press the brake pedal, Cybertruck powers up and indicator lights flash briefly. Unless an indicator light
applies to the current situation (for example, a seat belt is not fastened), it should turn o. If an indicator light fails to
turn on or o, schedule a service appointment.
Cards
The bottom of the vehicle status display also shows shortcut "Cards" for quick access to Media, tire pressure data,
trip information, and more. Swipe the cards to the left or right to customize your cards shortcuts.
Indicator Lights
The following indicator lights illuminate to advise or alert you of a specific status or condition.
A brake system fault is detected or the brake
fluid level is low. See Braking and Stopping on page
87. Contact Tesla immediately.
The parking brake is manually applied. See
Parking Brake on page 89.
A seat belt for an occupied seat is not fastened. See
Seat Belts on page 39.
Airbag safety. If this indicator does not
flash on briefly when Cybertruck prepares to drive, or if it
remains on, contact Tesla immediately. See Airbag Status Indicator on page 50.
A door or the
powered frunk is open.
Cybertruck
detects a faulty electrical connection for the trailer lights. Some, or all, trailer lights may
not be functioning. Pull over as soon as safety permits and inspect the trailer lights for faulty
cabling or connections. If the issue is resolved and the red icon persists, manually turn Trailer Mode
o and on again. See Towing a Trailer on page 105.
Vehicle Status
14 Owner's Manual
To Next Page
Loading...
