Pull Onto Truck - With Tow Eye
1. Locate the tow eye.
2. Remove the tow eye cover by inserting a
small flat screwdriver into the slot along
the top of the cover, then prying gently to
release the cover from the top snap.
3. Fully insert the t
ow eye, then turn it
counter-clockwise until securely fastened.
4. Attach the winch cable to the tow eye.
5. Pull the vehicle slowly onto the truck.
6. Shift the vehicle into Park by pressing the
button on the end of the gear selector.
Caution: Bef
ore pulling, make sure the
tow eye is securely tightened.
Pull Onto Truck - Without Tow Eye
It is s
trongly recommended that you connect
the winch to your vehicle's tow eye, as
described previously. However, if a situation
arises in which the tow eye is not available
(lost, misplaced, etc.), the instructions below
describe how to attach tow straps.
1. Attach the tow straps to the large hole on
each of the rearmost lower suspension
arms underneath the front of the vehicle.
2. T
o protect the underbody from any
damage, place a protective barrier (such
as a piece of wood) between the tow
strap and the underbody.
3. Pull the vehicle slowly onto the truck.
4. Shift the vehicle into Park by pressing the
button on the end of the gear selector.
Secure the Tires
The vehicle's tires must be secured onto the
truck using the eight-point tie-down method.
• Ensure any metal parts on the tie-down
straps do not contact painted surfaces or
the face of the wheels.
• Do not place tie-down straps over body
panels or through the wheels.
Instructions for Transporters
5
To Next Page
Loading...
