Topping Up Windshield Washer
Fluid
The only reservoir into which you can add
fluid is the windshield washer fluid reservoir,
which is located behind the front trunk. When
the level is low, a message displays on the
instrument panel.
To top up the washer fluid:
1. Open the hood.
2. Clean around the filler cap before opening
it to prevent dirt from entering the
reservoir.
3. Open the filler cap.
4. While avoiding spilling, fill the reservoir
until the fluid level is visible just below the
filler neck. The reservoir has a capacity of
liters.
5. Wipe up any spills immediately and wash
the aected area with water.
6. Replace the filler cap.
Note: Some national or local regulations
restrict the use of Volatile Organic
Compounds (VOCs). VOCs are commonly
used as antifreeze in washer fluid. Use a
washer fluid with limited VOC content only if it
provides adequate freeze resistance for all
climates in which you drive Model S.
Caution:
Do not add formulated washer
fluids that contain water repellent or bug
wash. These fluids can cause streaking,
smearing, and squeaking or other noises.
Warning: In temperatures below
40° F (4° C), use a washer fluid with
antifreeze. In cold weather, using a
washer fluid without antifreeze can impair
visibility through the windshield.
Warning: Windshield washer fluid can
irritate eyes and skin. Read and observe
the instructions provided by the washer
fluid manufacturer.
Fluid Reservoirs
186 Model S Owner's Manual
To Next Page
Loading...
