Tesla MODEL S - Page 92

HOLD State
When following a vehicle, Trac-Aware Cruise
Control remains active at low speeds, even
when Model S comes to a full stop. When the
vehicle is moving again, Trac-Aware Cruise
Control resumes operating at the set speed.
However, under the following circumstances,
Trac-Aware Cruise Control goes into a HOLD
state, in which case, you need to briefly press
the accelerator pedal or pull the cruise control
lever toward you (see Canceling and
Resuming on page 92) to resume cruising.
When the HOLD status is active, the
instrument panel displays the HOLD icon and
a message that indicates that you need to
resume cruise control. The following
circumstances can cause Trac-Aware Cruise
Control to go into the HOLD state:
• Model S has been at a standstill for 5
minutes.
• Model S detects a pedestrian (the HOLD
state may clear when the pedestrian is no
longer detected).
• Model S suddenly loses visibility of the
vehicle in front of you.
• The ultrasonic sensors detect an obstacle
in front of Model S.
Cruising Near or On Freeway Exits
When cruising near an exit on a controlled
access road (such as a highway or freeway)
and engaging the turn signal toward the exit,
Trac-Aware Cruise Control assumes you are
exiting and begins to slow down the vehicle. If
you do not drive onto the exit, Trac-Aware
Cruise Control resumes cruising at the set
speed. In a region with right hand trac, this
occurs only when you engage the right turn
signal when driving in the right-most lane
within 164 feet (50 meters) of an exit. Likewise
in regions with left hand trac; when
engaging the left turn signal when driving in
the left-most lane within 164 feet (50 meters)
of an exit.
Note: The onboard Global Positioning System
(GPS) determines if you are driving in a region
with right or left hand trac. In situations
where GPS data is unavailable (for example, if
there is inadequate signal), engaging the turn
signal near an exit does not cause Trac-
Aware Cruise Control to slow down Model S.
When enabled while on a highway interchange
or o-ramp, Trac-Aware Cruise Control may
reduce your set speed in 5 mph (5 km/h)
increments – to as slow as 25 mph (40 km/h)
– to better match the reported speeds of
other Tesla vehicles that have driven at that
specific location. To override this and continue
cruising at your set speed, tap the accelerator
pedal or move the cruise stalk. The new set
speed is maintained for the duration of the
interchange or o-ramp (unless you override it
or cancel Trac-Aware Cruise Control). After
the interchange or o-ramp, the set speed
may revert or change as necessary based on
the new location. For example, if you merged
onto a dierent highway, the set speed reverts
back to the set speed that was in use before
driving on the interchange.
Warning: In some cases (such as ha
ving
insucient data), Trac-Aware Cruise
Control may not automatically reduce the
set speed on the highway interchange or
o-ramp. Do not rely on Trac-Aware
Cruise Control to determine an
appropriate driving speed. Tesla
recommends driving at a speed that is
safe for road conditions and within
posted speed limits.
Adjust the Following Distance
To adjust the following distance you want to
maintain between Model S and a vehicle
traveling ahead of you, rotate the cruise
control lever to choose a setting from 1 (the
closest following distance) to 7 (the longest
following distance). Each setting corresponds
to a time-based distance that represents how
long it takes for Model S, from its current
location, to reach the location of the rear
bumper of the vehicle ahead of you.
As you rotate the cruise control lever, the
ins
trument panel displays the current setting.
Release the lever when the desired setting is
displayed.
Trac-Aware Cruise Control
Autopilot 91