Removing the soft-top
WARNING: Never attempt to remove
the soft-top while the vehicle is moving.
This could cause an accident in which you or
others may be seriously injured or killed.
S
Caution: It is recommended that you
release the side towards the front of the
vehicle first to prevent the adjusters for the
tensioning cables from damaging the seals.
1. With the vehicle stationary, open doors.
2. Locate the two release levers on the inside
face of the side rail.
3. Press both levers inwards to release the
side rail locking pins and rotate the rail
upwards. You may need to push down on
the side rail while pressing the levers.
4. Lift the side rail to disengage the two
locating pins from the front and rear
header rails.
5. Release the front and rear edges of the
soft-top from the channels in the header
rails and then roll the soft-top towards the
center of the vehicle.
6. Repeat the above steps for the other side.
7. Remove the soft-top from the vehicle and
store in the soft-top bag.
8. Remove the two soft-top support stays
from the vehicle. Flex the ends of the stays
inwards to release them
9. Store the soft-top support stays in the bag
with the soft-top.
Note: If the soft-top is damp when removed, it
is recommended that it is unrolled or refitted
at the soonest opportunity to allow it to dry
completely. Prolonged storage of a damp
soft-top can cause damage.
To Next Page
Loading...
