You can also fold the second row seat backs fully
forward by pressing the corresponding switch located
on the left side of the rear trunk. Pressing the switch
causes the seat back to swing forward. You can then
push it downward so it lays fully
flat.
To return the seat backs to their upright position, pull it
upwards until it locks into place. To confirm that the seat
back is locked in the upright position, try pulling it
forward.
NOTE:
Before raising a second row seat back, make sure
that the seat belts are not trapped behind the backrest.
WARNING: Always ensure the seat backs are
locked in their upright position by pushing it
forward or rearward. Failure to do so increases the
risk of injury.
Moving Second Row Seats (7-seater
only)
Lift the bar located beneath each outboard seating
position to unlock and move the second row seats
forward or rearward. The bench seats have a 60/40
split. Therefore, the bar on the left side moves the seat
for the left and center seats, whereas the bar on the
right side moves only the rightmost seat. Pull up and
hold the bar while moving the seat forward or rearward.
Release the lever when the seat is at the desired
location. Push the seat rearward and forward to ensure
the seat(s) are locked into position.
Accessing Third Row Seats (7-
seater only)
A third row ingress button is located on the backrest of
each second row outside seat. This button makes it easy
for passengers to access the third row seating positions.
To access a third row seat:
1.
Press the button on the associated second row
backrest.
NOTE: If you press the button and do not move the
seats, the seats relock.
2.
Push the second row backrest forward. The seat then
releases and pitches upward.
3. Push the seat fully forward.
Front and Rear Seats
26 MODEL Y Owner's Manual
To Next Page
Loading...
