To Next PageTo Next PageWhy Tesvor Robotics X500 does not clean automatically as scheduled?
If your Tesvor Robotics X500 does not perform cleaning work automatically as scheduled, it may be because scheduling failed. The remote control scheduling must be in a non-sleep state, and there is a voice prompt for the start and success of scheduling. Also, the robot needs to be rescheduled after it has been powered off.
Why does my Tesvor Robotics X500 suddenly make a noise?
If your Tesvor Robotics X500 suddenly makes noise, it could be due to deformed side brushes or the rolling brush. To identify the source, remove the side brushes and the rolling brush one at a time to see if the noise persists. If the noise stops after removing one of these, replace that accessory with a new one.
What to do if Tesvor Robotics X500's movements are abnormal?
If the Tesvor Robotics X500's movements or travel path are abnormal, it might be due to a software issue. First, carefully clean the sensors with a dry cloth. If the problem continues, restart the X500 by turning the power switch off and then back on.
General| Battery Capacity | 2500 mAh |
|---|---|
| Dustbin Capacity | 600 ml |
| Battery Type | Lithium-Ion |
| Mopping Function | Yes |
| Control | App |
| Dimensions | 330*330*74mm |
| Features | Virtual Walls |
| Noise Level | 65 dB |
| Run Time | 100-120 minutes |
