31
EN
PROBLEMS
PROBLEMS RELATING TO WATER FLOW
Some error messages of the control panel can be referred to correct water flow problems in the heater and
the filtering circuit.
When such problems occur, proceed in order to restore the minipool proper operating conditions.
In particular:
• Check filter cleaning by following the specific instructions for each minipool model.
• Check water level which must always cover the spa jets in compliance with the specific instructions for
each minipool model.
• Make sure the air intake system is not occluded.
• Make sure there is no air inside the pumps that may jeopardise their functioning.
After having checked the above, switch off product, the switch it on again and repeat the procedures ex-
plained by the section “FIRST STARTING OF THE MINIPOOL AFTER PURCHASING OR STORAGE/EMP-
TYING - PRIMING MODE“.
To Next Page
Loading...
