28
629
EN
The appliance is equipped with various safety features which monitor the operation of the
system. In the event of malfunction, the system responds automatically by deactivating the
function currently selected and displaying an error message.
REPAIRS
DIAGNOSTICS MESSAGES
REMOVING SCUFFS, SCRATCHES AND CIGARETTE BURNS
Firstly, make certain that the scratch or burn
has affected only the surface of the acrylic
material.
This type of repair must be entrusted to a pro-
fessional with the necessary skills.
ACRYLIC
FIBREGLASS
If any part of the appliance fails to operate as it should, (e.g. failure of the lamp in the
underwater light), call the nearest Teuco Authorized Service Centre (see list attached).
CAUSE
Filters dirty or blocked.
Temperature of water in the
minipool too high.
Sudden loss of electrical power with
water heater in operation. water
temperature too high
Pump valves closed or filter
blocked.
Problem with temperature probe.
Water level too low.
Safety temperature sensor problem.
ACTION
Clean the filters .
Set a lower temperature value and
wait for the water to cool.
If the fault persists, call the nearest
Teuco Authorized Service Centre.
Isolate the minipool from the power
supply and wait for the water to cool
down (about 2 hour). Power the
system up again, and if the fault
persists, call the nearest Teuco
Authorized Service Centre.
Check that the pump valves are
open; clean the filters. Switch
power off and on again. If the fault
persists, call the nearest Teuco
Authorized Service Centre.
Call the nearest Teuco authorized
Service Centre.
Add water, and if the problem
persists, contact a Teuco
Authorized Service Centre.
Call authorized technical
assistance.
TROUBLE OR FAULT
» CLE
» HO
- The temperature of the water in
the minipool is higher than 44 °C.
» HOH
- The temperature of the water in
the heater is higher than 51 °C.
» FLO
- The system is not sensing any
flow of water in the recirculation
circuit.
» rPF
» H2O
» HPF
To Next Page
Loading...
