12
Setup: Extending Your System
Adding to an existing system
If you already own an installed Raumfeld
system and would like to add a further
Controller, please follow the instructions
below.
1. Turn on the Raumfeld Controller by
briefly pressing the On/Off button.
2. After a few seconds the Raumfeld
setup screen will be displayed and
the setup wizard will activate. Please
follow the path “Connect to existing
system”.
≥ In an unconfigured Raumfeld system
the setup wizard will automatically be
started as soon as the Controller is turned
on. In order to access the setup wizard at
a later stage choose “Settings > Reset >
Controller Configuration”.
KURZ DRÜCKEN
To Next Page
Loading...