Texecom Premier Elite 8XP-W - Update Devices; Immediate Device Attribute Update; Update Devices Broadcast Failure

Premier Elite 8XP-W & 32XP-W Installation Manual
36 INS467-4
2 Hops
In this example the device is hopping through device
18 & 6 and the relevant signal strength is shown.
  
 
Update Devices
Used to immediately update devices (NOT SmartKey™) attributes when changed in the Device List
menu.
 
   
  

 
 

/


/

If the Update Devices broadcast message fails the following will be seen
 
   
 
   
 
 

/


/

In this case the system has not had time to synchronise properly, if you are in Commission Mode
(page 44) you should wait 4 minutes and try again. If not in commission mode you should wait 15
minutes and try again.