Premier Elite Com GSM Module Installation Manual
2 INS315-4
1. Introduction
The Premier Elite Com GSM is a 2G module that can be connected to any Premier or Premier Elite control
panel; however functionality differs depending on the type of Premier panel installed and the type of SIM card
that is used. The tables below show which features are available and the type of SIM card required to enable the
services.
Premier 24 SIM Type Panel Port Type
Report system events (alarms, arm, disarm etc.) via
text messaging to mobile telephones
Remotely arm, disarm and obtain current status of
the alarm system via text messaging
Upload/Download Via GSM
Alarm reporting to IP enabled receivers (Montex for
example) GPRS
Upload/Download Via IP GPRS
Premier 48/88/168/640
Premier Elite 24/48/88/168
SIM Type Panel Port Type
Feature Dynamic IP Fixed IP GSM Module Com IP
Report system events (alarms, arm, disarm etc.) via
text messaging to mobile telephones
Remotely arm, disarm and obtain current status of
the alarm system via text messaging
Upload/Download Via GSM
Alarm reporting to IP enabled receivers (Montex for
example) GPRS
Upload/Download Via IP GPRS
Premier 412/816/816 Plus/832 SIM Type Panel Port Type
Feature Dynamic IP Fixed IP GSM Module Com IP
Report system events (alarms, arm, disarm etc.) via
text messaging to mobile telephones
Remotely arm, disarm and obtain current status of
the alarm system via text messaging
Upload/Download Via GSM
Alarm reporting to IP enabled receivers (Montex for
example) GPRS
Upload/Download Via IP GPRS
A secondary form of communications should be used as back up where possible.
When using Alarm reporting over IP with Montex, SIA, Contact ID or, Fast Format may be used,
however if using Texbase SIA is NOT supported. Some receivers may require a Fixed IP address,
please check with your provider.
The Com port type must be programmed as one or the other, it is not possible to use both GSM and
GPRS (IP Only) functionality at the same time.
To Next Page
Loading...