Texecom Premier Elite OH-W - Standards and Certifications; Alarm System Standards Compliance; EMC and R&TTE Compliance; Environmental and Frequency Band Information

The Premier Elite OH-W is designed to detect the presence of fire and activate an alarm control panel. As the Premier
Elite OH-W is not a complete alarm system, but only a part therof, Texecom cannot accept responsibility or liability
for any damages whatsoever based on a claim that the Premier Elite OH-W failed to function correctly. These
instructions are intended as a guide only, always consult Local and National Standards where applicable.
Due to our policy of continuous improvement Texecom reserves the right to change specification without prior notice.
Standards
Alarm Systems: EN14604, EN50131-5-3, EN50131-1, PD6662:2010, Grade 2 Class II
EMC:
EN50130-4:
ETSI EN301
R&TTE: ETSI EN300-220
Environmental: EN50130-5
Frequency Band:
(See product label)
868.0 - 868.6 MHz
866.0 - 866.6 MHz
433.05 - 434.79 MHz
Receiver: Category 1, Class 2
Receiver LBT
(Listen Before Talk)
Yes
Transmitter Duty Cycle 868MHz<1%, 866MHz<1%, 433MHz<10%
Low Voltage Signal 2.85V
Operating Voltage 3V
Certificate Number: FM 35285
Specications
Unique ID codes Over 1 billion
Supervisory Interval 15 minutes
Spacing rating 21m
Audible Signal 85dBA min. in alarm
Sensitivity 5 - 3.5%/foot
Max current 50mA
Alarm Current 20mA
Supervisory Current 25 uA
Battery Life Up to 1.5 years
Operating temp. 4.4˚C to 37.8˚C
Dimensions 125mm x 63mm high
Relative humidity Max. 90%
Weight (Inc Batteries) 243g
Warranty 2 years (excluding batteries)